Mission 30 : A matter of leaking...

If you have run the cooling system you made in the previous mission, you may have encountered a little problem. When there is no molten metal block to cool, the system is putting water everywhere.

In this mission, we'll improve that in order to prevent water from leaking. We'll make a water recovery system.

If you have made a mess of water, the easier way to clean it is to put some blackrocks to replace the water blocks in order to remove them.

To make the recovery system, you need to make four Slow T0 Pumps and use one Atomic Compressor.

First, make a deep ditch around the conveyor track to recuperate the leaking water. You must make it at least one cube away from the track to prevent molten metal cube from falling into it.

In the bottom of the ditch, make a wide area. Put an atomic compressor and 4 pumps, one on each side of the atomic compressor. Make sure the pump have at least one cube of clearance around to work correctly.

Once done, the leaking water will be recovered in the atomic compressor and won't spread everywhere.

Your system is much better, bot not yet perfect. We'll see further how to convey the water from the recuperation system to the spraying storage. Bet at this point, you don't have the materials and machine to make the needed components.

When you have tested your recuperation system and it is fully working, your mission is over.